You are here


Other PCB Design Samples

Other PCB Design samples can be found here.


Combiner/splitter board with printed RF components

This is part of an RF system PCB to allow multiple modules to share the same antennas.

Initial design of the printed RF components was done in PUFF and final validation in a full structure FDTD simulator.

10mm x 10mm BT miniature module

This is part of a panel of a 10mm x 10mm RF BGA module. To minimize the form factor, a double sided design was developed (with the baseband in between the BGA balls on the bottom side).

Here below a snapshot of the assembled module: